MyPort = new Serial(this, "COM3", 9600) Serial.println(myIMU.readFloatGyroZ(), 4) Serial.println(myIMU.readFloatGyroY(), 4) Serial.println(myIMU.readFloatGyroX(), 4) Serial.println(myIMU.readFloatAccelZ(), 4) Serial.println(myIMU.readFloatAccelY(), 4) Serial.println(myIMU.readFloatAccelX(), 4) = 1 //Set to include accelerometer in the FIFO Serial.println("Processor came out of reset.\n") put your setup code here, to run once: LSM6DS3 myIMU //Default constructor is I2C, addr 0圆B The arduino code for the accelerometer/gyroscope signal and Processing script were found from Sparkfun's site:īelow are the code segments I am working on:Īrduino Signal Reading- #include "SparkFunLSM6DS3.h" Currently my arduino code reads the data over COM3 and I'm running into an within the Processing code that looks like "Error opening Serial Port COM3: Port not found". I'm trying to dump signal data over the arduino's channel using a Processing script.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |